After you send the request, you're done searching.
A boiler is not a common thing to find in an Arizona home. Most houses here heat with electricity, so if you've got one, it's likely doing more than space heating, maybe a radiant floor system, maybe something that came with the house from before. Water pooling at the base, dripping from a pipe joint, or showing up on the floor near the unit means something inside has given out, and it won't fix itself.
A leak can come from a few places. The pressure relief valve lets go when pressure builds too high. A fitting or valve can loosen or corrode over time. The tank itself can crack, and if that's what happened, the unit is done. None of these get better with time, and running a boiler low on water or losing pressure steadily can damage parts that were otherwise fine.
Because boilers aren't common here, not every contractor works on them regularly. The one matched to your request does, year-round, in this state's dry heat and against whatever corrodes faster or slower because of it. That's who looks at your unit, not a rotation of whoever's free.
Send the request and the search is over. You stop being the one calling around, checking licenses, waiting on quotes. One contractor gets your information, local and licensed, and they're the one who calls, not three or four companies working off the same lead. That's less noise at a time when you've already got water on the floor and a decision to make.
Leave the boiler alone until someone's looked at it. If the leak is near anything electrical, or the water's hot, keep clear and keep others clear too. The rest of this page covers what usually causes a leak like this and what tends to need doing about it.
Why is my boiler leaking water?
A puddle under the boiler or water dripping from a pipe is unsettling, especially when the unit is tucked away in a closet or utility room you don't check often. You want to know if this is something that gets fixed on the spot or something that means the whole system is done for. Since boilers aren't common in Arizona homes to begin with, finding a repair tech who actually knows this equipment matters more here than it would somewhere this is the usual setup.
Usually a worn seal, a loose fitting, or too much pressure in the system
Most leaks come down to a few spots. The pressure relief valve lets water out when pressure builds too high, often a sign the expansion tank or pressure regulator isn't doing its job anymore. Pump seals wear out over years of use and start weeping around the shaft. Fittings and valves can loosen or corrode at the joint. None of these mean the boiler is finished, but they do mean something specific has failed and needs a tech who can trace the leak to its source rather than just tightening the nearest bolt. A boiler that's part of a radiant floor system or an older setup that came with the house is worth having looked at by someone who works on this equipment regularly, since it isn't the typical heating setup found in Arizona homes.
You walk past the utility closet before sunrise and hear it before you see it, a thin tap of water hitting the floor. Inside, the boiler's pressure relief valve has let go, and a dark ring has spread out across the concrete from the base of the tank. The air outside is already dry, the kind of January morning that never fogs a window in Phoenix, so the puddle just sits there, not evaporating fast like it would in July. You touch the floor near the baseboard and it's damp an arm's length away. The closet smells faintly of hot metal and mineral. You shut the door and go find a towel.
What's that water doing under your boiler
You might find the puddle before you hear anything, a damp patch on the floor near the base of the boiler, or rust-colored water staining the wall behind it. Sometimes it shows up as a hiss or a slow drip you only catch when the house is quiet. Check the fittings and the pressure relief valve first, since that's where leaks usually start. Left alone, the water will find the nearest metal and start corroding it, and if that metal is part of the boiler's own housing or the gas line nearby, the damage spreads past what a simple reseal can fix.
Only one pro gets your request, so you hear from one company.
Asking costs nothing, and the choice to hire stays yours.
Why the valve is often the cause
The pressure relief valve sits on top of the tank for one reason: to open before the tank takes on more pressure than it can hold. It does its job by letting water out. If it's weeping or dripping, that doesn't always mean the valve itself is bad. It can mean the pressure inside is building higher than it should, and the valve is doing exactly what it's supposed to do. Either way, a valve that keeps releasing water needs a licensed hand on it, since the fix depends on which of the two it is.
What a slow leak can do over time
A boiler leaking even a small amount of water isn't a problem that holds steady. Water finds the weak point in a seal or a fitting and works at it. Left alone, a drip can turn into a steady trickle, and the metal around it can corrode faster than the rest of the tank. In a closet or utility room, that water also has nowhere to go, so it sits against the floor and the wall behind the unit. A leak caught early is a smaller repair than one caught late.
Winter nights average 39°F statewide
Nights here only get down to about 39°F in the dead of winter, so your boiler isn't running hard or often. A leak isn't from strain. It's a seal or valve that's given out and needs a look regardless of how light the duty has been.
NOAA nClimDiv 1991-2020 county normals weighted by homes
A leaking boiler in Arizona is almost never about the weather asking too much of it. It's a valve, a seal, or a fitting that's given out and needs a hand, not a system straining to keep up with a hard winter it doesn't really have. Because a boiler like yours isn't the usual setup around here, it helps to have someone who already knows this equipment rather than someone guessing at it for the first time. The contractor who takes this job is local and licensed, and works on boilers and radiant systems often enough to know where they tend to fail and what a leak like this usually means. You'll hear from one contractor, not a handful of them competing for your attention, so there's no sorting through calls to figure out who actually knows what they're doing. You send the request once. From there, finding the right person for a job like this stops being something you have to manage.
Boiler Repair
It's off your list after this
Step 1 of 3: Equipment
Say what's going on with your boiler, and a pro who works on them reaches out.
A local pro who knows boilers gets your details and gets in touch.
After this form, you can stop searching for a boiler pro.
One request and the search for a pro is handled.
Explain the job once and skip repeating it on every call.
Skip searching for a boiler pro and answer a few questions instead.
Your request goes to one pro, not a list of companies.